120mm LOW CROWN TOE PANEL BEATING DOLLY

Related products

• 

  BALL JOINT SERVICE TOOL SET WITH 4X4 ADAPTOR

  Kennedy Ball Joint Servicing Kit

  Made from cast iron and hardened carbon steel, this kit is designed for the removal of press fit type ball joints without having to remove the control arm from the vehicle. The kit can also be used for removing brake anchor pins and the servicing of universal joint bearings.
  Set Includes all the receive tubes and removing/installing adapters needed for press fit parts such as ball joints, universal joints and truck brake anchor pins.

  This tool kit is designed for servicing universal joints on all cars and light trucks that have press-fit type ball jointswithout the need to remove the control arm from the vehicle

  Contents:
  1 x C-frame press and Forcing Screw.
  3 x Receiver tubes: 2-3/4″ x 3″ / 2-1/4″ x 2-1/2″ / 1-3/4″ x 2″
  Installation/Removal Adaptor & Cups
  4-wheel drive ball joint service kit for 1967-present 1/2 & 3/4 ton vehicles with Dana 44 front axle, (eg: Ford, GM, Dodge, IHC & Jeep).

  Read more
• 

  DIESEL INJECTION PUMP PULLER FOR BMW M47/M57

  Kennedy Diesel Injection Pump Puller

  For the removal of diesel injection pumps from the following engines: DPP010, DPP020, DPP030.

  Read more
• 

  BATTERY TESTER

  Kennedy Battery Fluid Tester

  Tests 6, 12 and 24 volt batteries. Tough glass tube construction with colour coded float for easy reading which indicates the state of charge in each cell. Displays the specific gravity with a scale range of 1.100 to 1.300.

  Add to cart
• 

  COOLING SYSTEM & RADIATOR PRESSURE TESTER

  Kennedy Pressure Tester

  Cooling System & Radiator Cap Pressure Tester
  Designed for the pressure testing of cooling systems and radiator caps up to 35psi (2.5bar). Suitable for use on most makes of car and commercial vehicles, including: Mercedes, Ford, Chrysler, Peugeot, Honda, Lexus, Mazda, Suzuki, Toyota, Nissan, Opel, Volkswagen, Saab, Volvo, Audi, Citroen, Fiat and BMW.
  Contents: 14 radiator pressure testing caps, for use in testing cooling systems for leaks.
  Two cap adaptors, sizes 2 – 3 and 4 – 5, for testing radiator cap release pressure and seal condition. Two 200psi coolant hoses (5/16” and 3/8”), for use with T-adaptor for in-line pressure testing. T-adaptor for creating in-line pressure testing set-up. Two 3/4” hose clips.

  Read more